USGlobalSat GPS Forums

Please login or register.

Login with username, password and session length
Advanced search  


Pages: [1]   Go Down

Author Topic: Connect et-332 to arduino  (Read 2717 times)


  • Guest
Connect et-332 to arduino
« on: July 15, 2012, 01:19:32 am »

i'm trying to read gps(global sat et-332) tx output using arduino mega 2560
i've connected gps tx to arduino rx1
gps configured to work in nmea mode, if i connect it to pc - i get perfect nmea output

but when i try to read gps's data i get only
Code: [Select]
baud rate's are ok

when i connect same gps tx pin to pc - i get normal NMEA sentences....



  • Administrator
  • Hero Member
  • *****
  • Karma: 5
  • Offline Offline
  • Posts: 1755
Re: Connect et-332 to arduino
« Reply #1 on: July 16, 2012, 02:36:25 pm »

Just a couple of questions:

What do you mean by you're trying to read gps data?
How do you have it connected to the board when you're seeing those garbage characters?
Also, are you using any operating system with it? If so, can you please provide the operating system and version?
Can you please provide more details of how you're able to view those sentences?
Pages: [1]   Go Up

Page created in 0.166 seconds with 20 queries.