USGlobalSat GPS Forums

Please login or register.

Login with username, password and session length
Advanced search  


Pages: [1]   Go Down

Author Topic: Using with PIC microcontroller  (Read 3604 times)


  • Administrator
  • Hero Member
  • *****
  • Karma: 5
  • Offline Offline
  • Posts: 1755
Using with PIC microcontroller
« on: April 01, 2011, 12:30:38 pm »

Based on its datasheet (, the EM-408 outputs data in TTL. If the microcontroller is compatible with TTL, then it is possible to plug in this module's TX to the RX of the PIC, and its RX to the TX of the microcontroller.
This engine board only outputs real time GPS data in the NMEA protocol. The PIC microcontroller will be used to program this board.
You can also search online for further information on how to interface a GPS module to a PIC microcontroller
Pages: [1]   Go Up

Page created in 0.155 seconds with 18 queries.